2.5HP 2-Stroke Outboard Motor Gas Motor Fishing Boat Engine CDI System Ignition
2.5HP 2-Stroke Outboard Motor Gasoline Fishing Boat Motor Engine CDI System Good. Outboard Motor 2-Stroke 2.5 HP Fishing Boat Engine Motor W/CDI System Gasoline. Note: Before using the motor, please add gear oil to the gear and replace the gear oil after the running-in period (10 hours). Please do not equip our outboard engine with gear oil. Remember to refuel on the gear before use!! We can only provide CE certification, no other certification can be provided, thank you for your understanding. About noise: All gasoline engines are very noisy. At present, we have not tested decibels, but the noise is the same as that of motorcycles, so this is normal. The machine itself is light in weight and can be used on board no more than 100kg, with a load of 4 people, but the speed is definitely different when people or 4 people. Please pay attention to customers who have high expectations for speed. Can march with inflatable boats, rubber boats or fishing boats.
Necessary: You must prepare a boat motor bracket or hanging plate on board. Two strokes of 2.5 horsepower are controlled by the handle and the handle is operated by the clutch. No neutral, only idle mode or low speed mode. We do not provide consumables for free (such as pulling the starter). Maximum output power: 2.5HP.
Start the system: manually start. Staring at the carburetor system: choke start. Engine and propeller ratio: 2:1.Recommended fuel: ordinary unleaded gasoline. Fuel ratio: 25:1 (please note this version and ignore the manual on this). Top speed: 10 km / hour. Fuel consumption per hour: 1.5 liters.
After cruising in sea water or drowning. Use fresh water to clean the outboard motor.Circulate the engine at moderate speed. Do not leave the outboard motor outside until you have completely cooled the water. Otherwise the water cam enters the cylinder through the exhaust port. From there it will cause an engine failure. The engine should be stored in a dry and ventilated place to avoid direct exposure to the sun.
You should use up the gasoline in the tank before long-term storage. Don't do the following will avoid cylinder Scoring. Start the motor on bank. Use the motor when it stop coming out of water. Even if you want test the motor, it should be done in the river! When there is no water coming out from the motor, please stop using it immediately , then check the impeller of Water pump or check if the water outlet has been blocked.Feedback is very important to us. It is impossible to address issues if we do not know about them! Faction is our ultimate goal. We work hard to earn your trust and future business.
A If you receive a defective item, you may return it or ask for a discount. Due to time zones, our reply to your questions may not be immediately. If it's non-workdays, please kindly be patient and wait till Monday. The item "2.5HP 2-Stroke Outboard Motor Gas Motor Fishing Boat Engine CDI System Ignition" is in sale since Monday, September 14, 2020. This item is in the category "eBay Motors\Parts & Accessories\Boat Parts\Outboard Engines & Components\Complete Outboard Engines".
The seller is "top5zoom" and is located in Rowland Heights, California. This item can be shipped to United States.
- shipping notice: Can not ship to Puerto Rico,Alaska/Hawaii
- Note: not ship to Canarias
- Brand: Unbranded
- MPN: Does Not Apply
- Full throttle operating range: 4000-5000r / min
- Maximum output power: 2.5HP
- Speed: 10 km/h
- Type: 2 strokes
- Ignition System: CDI System
- Start the system: manually start
- Staring at the carburetor system: choke start
- Engine and propeller ratio: 2:1
- Gear ratio: 27/13
- Top speed: 10 km / hour
- Built-in fuel tank: 1L
- Fuel consumption per hour: 1.5 liters